Votes
Answers
Views
Question
0
votes
1
answer
74
views
0
votes
1
answer
155
views

The red light is on and the heating is not working. We have tried resetting but to no avail. How can we fix this?

0
votes
1
answer
76
views

Can the room sensor be used to replace existing mechanical gas Central Heating thermostat, and the floor sensor connect separately to electric underfloor heat mat? Thanks, Tom

0
votes
1
answer
63
views

Have c16 with 10m matt but not going higher then 14.5, can you please help

0
votes
1
answer
128
views

Do we need to change both? The temperature readings keep changing every few seconds

0
votes
1
answer
133
views

We have 2 Intelligent Controllers serving the underfloor heating under our large tiled kitchen floor. Both have been set to identical Custom programs (Period 1 with initial on at 7.00am and off at 9.00pm 7 days a week). However, one of the controllers doesn't seem to conform to the custom program timings and operates continuously. This is irrespective of the temperature - for example with a Custom temp of 23 degrees the heating remains on at midnight when measured temp is 19 degrees. Is it possible taht the controller has been wired in such a way as to by-pass the program settings or could there be another explanation?

0
votes
1
answer
79
views
0
votes
1
answer
146
views

Inside bathroom or outside bathroom?

0
votes
3
answers
152
views

How can I adjust the setback temperature? The option is mentioned in the manual but not available. By default the setback temperature (temperature of the floor outside of the comfort periods) is 5 degC lower than the comfort temperature. I want to stop the floor using *any* power during peak periods since I'm on a dynamic rate electricity tariff. Is this possible? This is a basic thermostat function.

0
votes
1
answer
123
views

I tried suggestions as touching both square and arrow up (only locks the settings) and both arrow up and arrow down, this gives code F1 - what does this mean?

0
votes
1
answer
208
views

I just want to turn it on and off when I need it

0
votes
1
answer
153
views

I had the heating on constantly using the old FHT. Now in manual mode I raise the set point temperature and it seems to reach this quickly and switch off heating but the floor is not as warm as I would like. Is there a recommended setting for constant ‘background’ for the set point figure?

0
votes
1
answer
187
views

I have a tiled floor in kitchen which we would like to warm up, to take chill off the tiles 8am to 10pm 7 days a week

0
votes
1
answer
189
views