« Back to Previous Page
Category:
▲
0
▼
♥ 0

I had the heating on constantly using the old FHT. Now in manual mode I raise the set point temperature and it seems to reach this quickly and switch off heating but the floor is not as warm as I would like. Is there a recommended setting for constant ‘background’ for the set point figure?

Marked as spam
Posted by dwsadmin (Questions: 180, Answers: 246)
Asked on December 17, 2020 10:54 am
153 views
Add comment
Cancel
▲
0
▼
✔
Private answer

Hi there , when in manual mode the controller will reach and heat at the set temperature and remain at that set temperature unless instructed otherwise.

Marked as spam
Posted by dwsadmin (Questions: 180, Answers: 246)
Answered on January 6, 2021 9:17 am
Add comment
Cancel
« Back to Previous Page